HP LaserJet 9000 HP LaserJet 9000 series printer User Guide - Page 144
Make sure that all power cables are firmly plugged in to both the printer components - default tray
View all HP LaserJet 9000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 144 highlights
Chapter 5 Problem solving 144 Situation Solution Printer draws paper from the wrong tray. z Be sure your program is selecting the correct paper size or type. z Make sure that the driver for your program is correctly installed, configured, and capable of requesting the desired paper size and type. z The size of paper requested is not loaded in the tray selected. The printer draws paper from the next default tray that contains the correct size. Load the correct paper in the tray and make sure the tray is adjusted correctly. Load the tray with enough paper to complete the print job. z If you selected Tray 2, 3, or optional Tray 4 and did not turn the printer off when installing it, the printer does not recognize it and draws paper from the next default tray source. Turn the printer off, then back on, and the printer will recognize the tray. Printer interface problems. Print a configuration page from the printer control panel to verify that the interface configurations shown on the printout match those on the host computer (See "Configuration page" on page 155). Printer is paused. Press PAUSE/RESUME. The printer control panel should display READY and the Ready light should be lit. Resume printing. Printer is off or not connected to an active power source. Make sure that all power cables are firmly plugged in to both the printer components and an active power source. Make sure the printer is on. Printer is ready, but not receiving data (the Data light does not blink). z Check for loose I/O cable connections at the printer and computer or network port. z Try your I/O cable on a system that you know works. z Check that the correct interface cable was selected and is securely connected to both the printer and the computer. If the cable is not correctly configured, see the start guide for configuration information. z If connected to a network, print a Jetdirect configuration page to check for interface or network problems (See "Configuration page" on page 155). Correcting output quality problems