HP LaserJet P4510 Service Manual - Page 301
XX ERROR, To continue turn off then on, XY ERROR, For help press, DIAGNOSTICS, XX ERROR, Tray 2 only
View all HP LaserJet P4510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 301 highlights
Table 7-9 Control-panel messages (continued) Control panel message Description Recommended action 58.XX ERROR To continue turn off then on The environmental sensor (TH3) has experienced an error. 1. Verify that the environmental sensor connection at connector J63 on the high-voltage power supply PCA is securely seated. 2. If the error persists, replace the environmental sensor (TH3). 59.XY ERROR For help press alternates with 59.XY ERROR To continue turn off then on A temporary printing error occurred. 1. Inspect the DC controller PCA and verify that the following connectors are firmly seated: ◦ Drum motor (M102) to connector J87 ◦ Feed motor (M101) to connector J91 ◦ Fusing motor (M299) to connector J89 NOTE: There is a cable between the drum motor and the DC controller. Both ends of the cable need to be firmly seated. 2. If the error persists, from the DIAGNOSTICS menu, run the component tests for each motor to verify that they are operating. If any of the motors is not operating, replace the motor. 60.XX ERROR An error has occurred while the product was 1. Open the tray, and then remove the attempting to lift the tray designated by XX. paper. 2. Open the guides and look for any torn pieces of paper or foreign objects inside the tray. 3. Replace the paper, and then close the tray. 4. Turn the product off and then on. 5. Remove most of the paper from the tray except for a few sheets, and insert the tray into the product. Listen for the sound of the lift motor lifting the paper stack. Also, observe if the paper level indicator moves at the front of the tray. 6. Tray 2 only: If the paper stack in the tray is not being lifted, verify that the lift motor connector is firmly seated in connector J73 on the DC controller PCA. 62 NO SYSTEM To continue turn off then on 7. If the error persists, replace the lift motor. This message indicates that no system was ● found. The product software system is corrupt. ● Turn the product off and then on. If the message persists, contact an HPauthorized service or support provider. ENWW Control-panel messages 287