HP Mellanox SX1018 Mellanox MLNX-OS User Manual for SX1018HP Ethernet Managed - Page 12
Getting Started
View all HP Mellanox SX1018 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Rev 1.6.2 2 Getting Started The procedures described in this chapter assume that you have already installed and powered on your switch according to the instructions in the Hardware Installation Guide, which was shipped with the product. 2.1 Configuring the Switch for the First Time - Installation Wizard Step 1. Connect to the HP Chassis Manager and run "connect interconnect ". No remote IP connection is available at this stage. Step 2. Configure a serial terminal from EM with the settings described below. Table 6 - Serial Terminal Program Configuration Parameter Baud Rate Data bits Stop bits Parity Flow Control Setting 9600 8 1 None None Step 3. Step 4. Login as admin and use admin as password to start the Mellanox configuration wizard. Go through the Mellanox configuration wizard. The following table shows an example of a wizard session. Table 7 - Configuration Wizard Session - IP Configuration by DHCP (Sheet 1 of 3) Wizard Session Display (Example) Mellanox configuration wizard Do you want to use the wizard for initial configuration? yes Step1: Hostname? [switch-1] Comments You must perform this configuration the first time you operate the switch or after resetting the switch to the factory defaults. Type "y" and then press . If you wish to accept the default hostname, then press . Otherwise, type a different hostname and press . Mellanox Technologies 12