HP Mellanox SX1018 Mellanox MLNX-OS User Manual for SX1018HP Ethernet Managed - Page 13
Step 2, Step 3, Step 4, Step 5
View all HP Mellanox SX1018 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Table 7 - Configuration Wizard Session - IP Configuration by DHCP (Sheet 2 of 3) Wizard Session Display (Example) Step 2: Use DHCP on mgmt0 interface? [yes] Comments Perform this step to obtain an IP address for the switch. (mgmt0 is the management port of the switch.) If you wish the DHCP server to assign the IP address, type "yes" and press . If you type "no" (no DHCP), then you will be asked whether you wish to use the "zeroconf" configuration or not. If you enter "yes" (yes Zeroconf), the session will continue as shown in Table 8. Step 3: Enable IPv6 [yes] If you enter "no" (no Zeroconf), then you need to enter a static IP, and the session will continue as shown in Table 9. Perform this step to enable IPv6 on management ports. If you wish to enable IPv6, type "yes" and press . Step 4: Enable IPv6 autoconfig (SLAAC) on mgmt0 interface If you enter "no" (no IPv6), then you will automatically be referred to Step 5. Perform this step to enable StateLess address autoconfig on external management port. If you wish to enable it, type "yes" and press . Step 5: Admin password (Press to leave unchanged)? Step 4: Confirm admin password? If you wish to disable it, enter "no". To avoid illegal access to the machine, please type a password and then press . Then confirm the password by re-entering it. Note that password characters are not printed. Rev 1.6.2 Mellanox Technologies 13