HP Mellanox SX1018 Mellanox MLNX-OS User Manual for SX1018HP Ethernet Managed - Page 21
Installing MLNX-OS License Web
View all HP Mellanox SX1018 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Step 3. Step 4. Display the installed license(s) using the following command. switch (config) # show licenses License 1: Feature: EFM_SX Valid: yes Active: yes switch (config) # Make sure that the "Valid" and "Active" fields both indicate "yes". Save the configuration to complete the license installation. Run: switch (config) # configuration write Rev 1.6.2 If you do not save the installation session, you will lose the license at the next system start up. 2.4.2 Installing MLNX-OS License (Web) To install an MLNX-OS license via CLI: Step 1. Log in as admin. Step 2. Click the Setup tab and then Licensing in the left side navigation pane. Figure 4: No Licenses Installed Mellanox Technologies 21
Rev 1.6.2
Mellanox Technologies
21
Step 3.
Display the installed license(s) using the following command.
Make sure that the “Valid” and “Active” fields both indicate “yes”.
Step 4.
Save the configuration to complete the license installation. Run:
2.4.2
Installing MLNX-OS License (Web)
To install an MLNX-OS license via CLI:
Step 1.
Log in as
admin
.
Step 2.
Click the
Setup
tab
and then
Licensing
in the left side navigation pane.
Figure 4: No Licenses Installed
switch (config) # show licenses
License 1: <license key>
Feature: EFM_SX
Valid: yes
Active: yes
switch (config) #
switch (config) # configuration write
If you do not save the installation session, you will lose the license at the next system
start up.