HP Mellanox SX1018 Mellanox MLNX-OS User Manual for SX1018HP Ethernet Managed - Page 56
Mlnx-os Xml Api
View all HP Mellanox SX1018 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Rev 1.6.2 Step 3. Verify the SNMP host configuration. Run: switch (config) # show snmp host Notifications enabled: yes Default notification community: public Default notification port: 162 Notification sinks: 10.134.47.3 Enabled: yes Port: 162 (default) Notification type: SNMP v3 trap Username: my-username Authentication type: sha Privacy type: aes-128 Authentication password: (set) Privacy password: (set) Step 4. switch (config) # Verify the list of traps and informs being sent to out of the system. Run : switch (config) # show snmp events Events for which traps will be sent: asic-chip-down: ASIC (Chip) Down cpu-util-high: CPU utilization has risen too high disk-space-low: Filesystem free space has fallen too low health-module-status: Health module Status insufficient-fans: Insufficient amount of fans in system insufficient-fans-recover: Insufficient amount of fans in system recovered insufficient-power: Insufficient power supply interface-down: An interface's link state has changed to down interface-up: An interface's link state has changed to up internal-bus-error: Internal bus (I2C) Error liveness-failure: A process in the system was detected as hung low-power: Low power supply low-power-recover: Low power supply Recover new_root: local bridge became a root bridge paging-high: Paging activity has risen too high power-redundancy-mismatch: Power redundancy mismatch process-crash: A process in the system has crashed process-exit: A process in the system unexpectedly exited snmp-authtrap: An SNMP v3 request has failed authentication topology_change: local bridge trigerred a topology change unexpected-shutdown: Unexpected system shutdown switch (config) # 4.8.2 MLNX-OS XML API MLNX-OS XML API is an additional option to manage the system (besides SNMP). The XML gateway provides an XML request-response protocol that can be used by end-user tools to get and set management information on the appliance. The service can be accessed over HTTP or HTTPS, and then it uses the existing web authentication mechanism. It can also be accessed over Mellanox Technologies 56