HP Model 712/100 hp 9000 series 700 model 712 service handbook (a2615-90039) - Page 102
Hard Disk
View all HP Model 712/100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
Hard Disk Before removing the hard disk, perform the following procedures: D Remove the stand. D Open the system unit. Perform the following steps to remove the disk drive: 1. Disconnect the SCSI and power cables from the hard disk. 2. Remove the disk retaining bracket by lifting the end closest to the rear of the system unit and rotating it toward the front of the system unit, as shown in Figure 5-16. Figure 6-16. Removing the Disk Retaining Bracket 5-26 Field Replaceable Units
5–26
Field Replaceable Units
Hard Disk
Before removing the hard disk, perform the following procedures:
D
Remove the stand.
D
Open the system unit.
Perform the following steps to remove the disk drive:
1.
Disconnect the SCSI and power cables from the hard disk.
2.
Remove the disk retaining bracket by lifting the end closest to the rear of the sys-
tem unit and rotating it toward the front of the system unit, as shown in
Figure 5–16.
Figure 6–16.
Removing the Disk Retaining Bracket