HP Model 712/100 hp 9000 series 700 model 712 service handbook (a2615-90039) - Page 105
Power Supply Cover
View all HP Model 712/100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
Power Supply Cover Before removing the power supply cover, perform the following procedures: D Remove the stand. D Open the system unit. D Remove the speaker. WARNING: Do not turn on the workstation with the power supply cover removed. Perform the following steps to remove the power supply cover: 1. Disengage the power supply cover locking tab by pushing a small flat blade screwdriver into the slot on the rear panel, as shown in Figure 5-19. Figure 6-19. Removing the Power Supply Cover Field Replaceable Units 5-29
Field Replaceable Units
5–29
Power Supply Cover
Before removing the power supply cover, perform the following procedures:
D
Remove the stand.
D
Open the system unit.
D
Remove the speaker.
WARNING:
Do not turn on the workstation with the power supply
cover removed.
Perform the following steps to remove the power supply cover:
1.
Disengage the power supply cover locking tab by pushing a small flat blade
screwdriver into the slot on the rear panel, as shown in Figure 5–19.
Figure 6–19.
Removing the Power Supply Cover