HP Model 712/100 hp 9000 series 700 model 712 service handbook (a2615-90039) - Page 118
Removing the Cover C1530B/C2954A Tape Drive
View all HP Model 712/100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
Remove the drive's components in the following order until you've removed the desired FRU: 1. Remove the cover. Push the locking latch to the side, slide the cover forward about an inch, and lift off (see Figure 5-28). Figure 6-28. Removing the Cover (C1530B/C2954A Tape Drive) 2. Lift out the top HP PAC. 3. Remove the drive. Lift the rear of the drive slightly and disconnect the power and SCSI cables. Lift the drive from the chassis. NOTICE: When replacing the drive, make sure the jumpers are set to the correct SCSI ID, as described in Chapter 3. 5-42 Field Replaceable Units
5–42
Field Replaceable Units
Remove the drive’s components in the following order until you’ve removed the
desired FRU:
1.
Remove the cover.
Push the locking latch to the side, slide the cover forward about an inch, and lift
off (see Figure 5–28).
Figure 6–28.
Removing the Cover (C1530B/C2954A Tape Drive)
2.
Lift out the top HP PAC.
3.
Remove the drive.
Lift the rear of the drive slightly and disconnect the power and SCSI cables.
Lift the drive from the chassis.
NOTICE:
When replacing the drive, make sure the jumpers are
set to the correct SCSI ID, as described in Chapter 3.