HP Model 712/100 hp 9000 series 700 model 712 service handbook (a2615-90039) - Page 123
Removing the Fan/LED Assembly C2943A, CD-ROM
View all HP Model 712/100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 123 highlights
4. Remove the Fan/LED assembly. Squeeze the clip on the side of the Fan/LED assembly cable connector to disconnect it from the power supply. From the front of the unit, push in the LED until it disengages from the chassis. Tilt the top of the fan toward the front of the unit until it disengages from the mounting pins, then lift out the Fan/LED assembly, as shown in Figure 5-32. NOTICE: When replacing the fan, make sure that the arrow on its side points toward the rear of the unit. Figure 6-32. Removing the Fan/LED Assembly (C2943A CD-ROM) 5. Remove the power button. Pull the power button straight off of the end of the plunger. Field Replaceable Units 5-47
Field Replaceable Units
5–47
4.
Remove the Fan/LED assembly.
Squeeze the clip on the side of the Fan/LED assembly cable connector to discon-
nect it from the power supply.
From the front of the unit, push in the LED until it disengages from the chassis.
Tilt the top of the fan toward the front of the unit until it disengages from the
mounting pins, then lift out the Fan/LED assembly, as shown in Figure 5–32.
NOTICE:
When replacing the fan, make sure that the arrow on
its side points toward the rear of the unit.
Figure 6–32.
Removing the Fan/LED Assembly (C2943A
CD–ROM)
5.
Remove the power button.
Pull the power button straight off of the end of the plunger.