HP Model 712/100 hp 9000 series 700 model 712 service handbook (a2615-90039) - Page 91
Top Cover
View all HP Model 712/100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
Top Cover Before removing the top cover, remove the stand. CAUTION: Do not attempt to operate the workstation with the top cover removed. The cover is needed for proper air flow for system cooling. Perform the following steps to open the system unit: 1. Lay the system unit on a flat surface, such as a table top. 2. Attach the static-grounding wrist strap by following the instructions on the package. Attach the the sticky end of the wrist strap to bare metal of the system unit. 3. Release the top cover by pushing the two locking tabs at the rear of the system unit toward the outside of the unit and then forward, as shown in Figure 5-6. 4. Slide the cover forward about two inches, then carefully lift to remove it, as shown in Figure 5-6. Figure 6-6. Opening the System Unit Field Replaceable Units 5-15