HP StorageWorks 2/64 HP StorageWorks Core Switch 2/64 Getting Started & Ge - Page 27
Separate the flanges from rear-mount brackets by removing the four, 10-32 pan-head screws
![]() |
View all HP StorageWorks 2/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
5. The two rear mounting bracket sets consist of a rear-mount bracket and a flange. Attach the two rear-mount brackets to the chassis by completing the following steps: a. Separate the flanges from rear-mount brackets by removing the four #10-32 pan-head screws, two screws per set (see Figure 9). Save the screws to reinstall the flanges later. Rear-Mount Bracket (1x set) Flange (1x set) Figure 9. Separating the Flange from the Rear-Mount Bracket #10-32 Pan-Head Screws (2x) Installing the Switch 19
![](/manual_guide/products/hewlettpackard-storageworks-264-hp-storageworks-core-switch-264-getting-started-general-reference-guide-4e71e98/27.png)
Installing the Switch
19
5.
The two rear mounting bracket sets consist of a rear-mount bracket and
a flange. Attach the two rear-mount brackets to the chassis by completing
the following steps:
a.
Separate the flanges from rear-mount brackets by removing the four
#10-32 pan-head screws, two screws per set (see
Figure 9
). Save the
screws to reinstall the flanges later.
Figure 9.
Separating the Flange from the Rear-Mount Bracket
#10-32
Pan-Head
Screws (2x)
Rear-Mount
Bracket
(1x set)
Flange (1x set)