HP StorageWorks 2/64 HP StorageWorks Core Switch 2/64 Getting Started & Ge - Page 73
Interpreting POST Results, Interpreting LED Activity,
![]() |
View all HP StorageWorks 2/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
16-Port Cards (Slots 1-4 and 7-10) Power LED (Upper LED) Status LED (Lower LED) CP Cards (Slots 5 and 6) Power LED (Upper LED) Status LED (Lower LED) Power Supplies Power LED (Left LED) Status LED (Right LED) 1 2 3 4 5 6 7 8 9 10 pwr4 o o oo oo oo oo o o oo oo o o o oo o pwr3 oo pwr2 oo pwr1 oo Figure 24. WWN Card and Bezel Interpreting POST Results Each time the switch is powered on or reset, the switch automatically performs POST, a system check during which LED patterns may vary. To verify that POST completed without errors: • Verify that all LEDs return to a normal state after POST is complete. If one or more LEDs do not return to a normal state, and this is not due to the switch being set to beacon, see "Interpreting LED Activity" on page 54. Use the slotShow command to check the status of the slots. For information about setting a switch to beacon, refer to the hp StorageWorks fabric os procedures guide. • Verify that the switch prompt displays when POST completes. If it does not display, POST was not successfully completed. Contact HP support. • Review the system log. Any errors detected during POST are written to the system log, accessible through the errShow command. For information about error messages, refer to the hp StorageWorks diagnostic and system error message reference. Operating the Switch 65
![](/manual_guide/products/hewlettpackard-storageworks-264-hp-storageworks-core-switch-264-getting-started-general-reference-guide-4e71e98/73.png)