HP StorageWorks MSA1000 HP StorageWorks 2/8q Fibre Channel Switch Management V - Page 115
Restoring a switch configuration, Config Restore, config_switch_169_10112003, images, Set Setup System
View all HP StorageWorks MSA1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
Command Line Interface Restoring a switch configuration The restore operation begins with FTP to upload the configuration file from the workstation to the switch, and then finishes with a Telnet session and the Config Restore command. To upload the configuration file, config_switch_169_10112003 in this case, open and FTP session with account name images and password images. Transfer the file in binary mode using the Put command as shown: ftp ip_address user:images password: images ftp> bin ftp> put config_switch_169_10112003 configdata Local file config_switch_169_10112003 Remote file configdata ftp>quit The restore process replaces all configuration information on the switch and afterwards the switch is automatically reset. If the restore process changes the IP address, all management sessions are terminated. Use the Set Setup System command to return the IP configuration to the values you want. See the "Set Setup command" on page 147. To restore the switch, open a Telnet session, and then enter the Config Restore command from within an Admin session as shown: 2/8q FC Switch #> admin start 2/8q FC Switch (admin) #> config restore The switch will be reset after restoring the configuration. Please confirm (y/n): [n] y HP StorageWorks 2/8q Fibre Channel Switch Management User Guide 115