IBM 2109 Service Guide - Page 112
cmemRetention test, cmiTest, DIAG-LCMRS, DIAG-CMNOBUF
UPC - 087944519355
View all IBM 2109 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
| Table 30. centralMemoryTest example (continued) | Example sw7:admin> centralMemoryTest | Running Central Memory Test ... passed. | | Related error messages: DIAG-CMBISTRO, DIAG-CMBISRF, DIAG-LCMTO, | DIAG-LCMRS, DIAG-LCMEM, DIAG-LCMEMTX, DIAG-CMNOBUF, | DIAG-CMERRTYPE, DIAG-CMERRPTN, DIAG-PORTABSENT, DIAG-BADINIT, | DIAG-TIMEOUT. | cmemRetention test | Table 31 shows the cmemRetentionTest command, which is used to verify that | data written into the SRAMs that make up the central memory are retained and that | data bits do not drop when read after some amount of delay since the write | operation. | Attention: This command cannot be executed on an operational switch. Before | using the cmemRetention test command, disable the switch using the | switchDisable command. | cmemRetention test example: The cmemRetention Test command performs a | data retention test of the central memory SRAMs. | Table 31. cmemRetention test example | Synopsis cmemRetentionTest [passCount] | Availability Administrator | Description Use this command to verify for data retention in the central memory | SRAMs in the ASIC. | Below are possible error messages if failures are detected: | | DIAG-LCMRS | DIAG-LCMTO | DIAG-LCMEM | Operands This command has the following operand: | passCount Specify the number of times to execute this test. The | default value is 1. This operand is optional. | Example sw7:admin> cmemRetentionTest | Running CMEM Retention Test ... passed. | | Related error messages: DIAG-LCMEM, DIAG-LCMRS, DIAG-LCMTO. | cmiTest | Table 32 on page 97 shows the cmiTest command, which verifies that control | messages can be correctly sent from any ASIC to any ASIC. It also tests that the | checksum check is OK. | Attention: This command cannot be executed on an operational switch. Before | issuing the cmiTest command, disable the switch using the switchDisable | command. | cmiTest example: The cmiTest command performs a ASIC to ASIC connection | test of the CMI bus 96 IBM SAN Fibre Channel Switch: 2109 Model S16 Installation and Service Guide