IBM 2109 Service Guide - Page 140
Message, Failing test, Description, Probable cause, Action, The POST is skipped. It's
![]() |
UPC - 087944519355
View all IBM 2109 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
| Table 41. Diagnostic error messages (continued) | Message Failing test Description Probable cause Action | DIAG-MEMSZ | Err#0111 ramTest The memory size to be tested is System board failure 1 less than or equal to zero. | DIAG-MEMORY | Err#0110 | ramTest Data read from the RAM location CPU RAM failure 1 did not match previously written data into the same location. | DIAG-NOSEGMENT crossPortTest | Err#3081 spinSilk | Err#3881 | | The port failed to go into loopback Improper GBIC or mode. cable connection Reseat the GBICs and cables and re-execute the test | DIAG-PORTABSENT portLoopbackTest | Err#2670 crossPortTest | Err#3070 spinSilk | Err#3870 The port is not present. ASIC or system board 1 failure | DIAG-PORTDIED | Err#265F | Err#305F | Err#385F portLoopbackTest crossPortTest spinSilk The port was in loopback mode and then went inactive. ASIC, GBIC module, 2 or fiber cable failure | DIAG-PORTM2M | Err#3080 | Err#3880 | | | | crossPortTest spinSilk The port is found to be conneced to itself (self loopback). This port M to port M connection is not allowed by this test. Improper cable connection Reconnect port (M) to another port (N) and re-execute the test | DIAG| PORTSTOPPED | Err#3874 | spinSilk The port is no longer transmitting, ASIC, GBIC module, 2 as indicated by the number of or fiber cable failure frames transmitted counter being stuck at N frames. | DIAG-PORTWRONG crossPortTest The frame was erroneously ASIC failure 1 | Err#3078 received by port M instead of the | intended port N. | DIAG| POST_SKIPPED | Err# 0004 switch initialization The POST is skipped. It's message recommended that POST be performed. Informational only None required | DIAG-REGERR portRegTest Data read from the ASIC register ASIC failure 1 | Err#0B15 sramRetentionTest or the ASIC SRAM did not match | Err#0415 the data previously written into the | same location. | DIAG- portRegTest The port failed to unreset. ASIC failure 1 | REGERR_UNRST sramRetentionTest | Err#0B16 | Err#0416 124 IBM SAN Fibre Channel Switch: 2109 Model S16 Installation and Service Guide
![](/manual_guide/products/ibm-2109-service-guide-22cdb62/140.png)