IBM 8671 Hardware Maintenance Manual - Page 111
Input/output
![]() |
UPC - 087944734307
View all IBM 8671 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
The following illustration shows how to install the left-side cover on the tower model server. Slots Left-side cover Complete the following steps to install the server left-side cover: 1. Before installing the cover, check that all cables, adapters, and other components are installed and seated correctly and that you have not left loose tools or parts inside the server. 2. Place the bottom lip of the left-side cover over the bottom edge of the server chassis. 3. Rotate the left-side cover to a vertical position, inserting the tabs at the top of the left-side cover into the matching slots in the server chassis. 4. Slide the left-side cover forward until it locks in place. 5. If you disconnected any cables from the back of the server, reconnect the cables; then, plug the power cords into properly grounded electrical outlets. Note: If necessary, see "Input/output connectors" on page 108 for connector locations. Chapter 4. Customer replaceable units 101
![](/manual_guide/products/ibm-8671-hardware-maintenance-manual-61e0001/111.png)