IBM 8671 Hardware Maintenance Manual - Page 67
Removing, server, cover, bezel, configuration
![]() |
UPC - 087944734307
View all IBM 8671 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Removing the server top cover and bezel (rack configuration) This section describes how to remove the top cover and bezel from a rack configuration server. Removing the top cover The following illustration shows how to remove the top cover from a rack configuration server. Top cover 1 FAN 1 2 3 A CPVURMMPCEMI BOURSY B POWER HDD 2 3 SUPNPMLSIYMSI EBRUVSICENOPNRORCEEDSUSNOTDREAMNPTERATURE Right-side latch Cover-release latch Left-side latch Complete the following steps to remove the server top cover: 1. Review the information in "Installation guidelines" on page 45, "Handling static-sensitive devices" on page 46, and "Safety information" on page 169. 2. Press down on the plastic cover-release latch on the front of the server. 3. While pressing the plastic cover-release latch, slide the top cover slightly toward the rear of the server; the cover will stop after approximately 25 mm (1 inch). Release the cover-release latch; then, lift the cover off the server and set the cover aside. Chapter 4. Customer replaceable units 57
![](/manual_guide/products/ibm-8671-hardware-maintenance-manual-61e0001/67.png)