IBM 8671 Hardware Maintenance Manual - Page 159
diagnostics.
![]() |
UPC - 087944734307
View all IBM 8671 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 159 highlights
Note: See "System" on page 162 to determine which components should be replaced by a field service technician. Error code/symptom FRU/action 289 (DIMM disabled by POST or user) 1. Run the Configuration/Setup Utility program, if the DIMM was disabled by the user. 2. Disabled DIMM, if not disabled by user. 301 (Keyboard or keyboard controller error) 1. Keyboard 2. System board 303 (Keyboard controller error) v System board 602 (Invalid diskette boot record) 1. Diskette 2. Diskette drive 3. Cable 4. System board 604 (Diskette drive error) 1. Run the Configuration/Setup Utility program and diagnostics. 2. Diskette drive. 3. Drive cable. 4. System board. 605 (Unlock failure) 1. Diskette drive 2. Drive cable 3. System board 662 (Diskette drive configuration error) 1. Run the Configuration/Setup Utility program and diagnostics. 2. Diskette drive. 3. Drive cable. 4. System board. 762 (Coprocessor configuration error) 1. Run the Configuration/Setup Utility program. 2. Battery. 3. Microprocessor. 962 (Parallel port error) 1. Disconnect the external cable on the parallel port. 2. Run the Configuration/Setup Utility program. 3. System board. 11XX (System board serial port 1 or 2 error) 1. Disconnect the external cable on the serial port. 2. Run the Configuration/Setup Utility program. 3. System board. 1301 (I2C cable to front panel not found) 1. Verify operator information panel cable is connected to J24 on system board. 2. Cable. 3. Front panel 4. Power switch assembly 5. System board 1302 (I2C cable from system board to power on and reset switches not found) 1. Verify power on and reset switch cable is connected to J23 on system board. 2. Cable. 3. Power switch assembly 4. System board Chapter 6. Symptom-to-FRU index 149
![](/manual_guide/products/ibm-8671-hardware-maintenance-manual-61e0001/159.png)