IBM 8671 Hardware Maintenance Manual - Page 135
Hot-swap, Diagnostics, panel
![]() |
UPC - 087944734307
View all IBM 8671 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
Hot-swap card Complete the following steps to remove the hot-swap card. Note: v Read "Installation guidelines" on page 45. v Read the safety notices at "Safety information" on page 169. v Read "Handling electrostatic discharge-sensitive devices" on page 172. 1. Turn off the server. 2. Disconnect all external cables and power cords from the back of the server. 3. Remove the server cover (see "Removing the left-side cover" on page 55). 4. Remove all adapters and spacers (see "Working with adapters" on page 60). 5. Disconnect the hot-swap card cable from the system board. 6. Press the two tabs on the hot-swap card and remove it from the chassis. Note: It might be easier to remove this component if the server is placed on its side. 7. To replace the hot-swap card, line up the two tabs with the notches on the chassis and snap the assembly into place; then, connect the cable to the system board. Diagnostics panel card Complete the following steps to remove the diagnostics panel card. Note: v Read "Installation guidelines" on page 45. v Read the safety notices at "Safety information" on page 169. Chapter 5. Service replaceable units 125
![](/manual_guide/products/ibm-8671-hardware-maintenance-manual-61e0001/135.png)