IBM 8671 Hardware Maintenance Manual - Page 69
System-board
UPC - 087944734307
View all IBM 8671 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
2. Turn off the server and disconnect all power cords and external cables ("Turning off the server" on page 9); then, remove the server cover (see "Removing the server left-side cover and bezel (tower model)" on page 55 or "Removing the server top cover and bezel (rack configuration)" on page 57). 3. Slide the air-baffle assembly out of the guides; then, remove it from the server. Air-baffle assembly 4. Disconnect any cables that are connected to the full-length adapters. 5. Lift the adapter-retention clip on top of the adapter-support bracket (for the location of this clip, see the illustration at "Installing a hot-plug adapter (slots 5 and 6)" on page 62); then, remove the full-length adapters and plastic dividers. 6. Disconnect the end of the cable that is attached to the center-fans connector on the system board (see "System-board internal cable connectors" on page 49). 7. Remove the adapter-support bracket. Centerfan bracket Adaptersupport bracket SCSI cable Adapter-support bracket latches a. Press the release tab on each adapter-support bracket latch. There are two latches; one at each end of the adapter-support bracket. Chapter 4. Customer replaceable units 59