IBM 8671 Hardware Maintenance Manual - Page 37
High-performance, Ethernet, modes, connector, Updating, integrated, system, management, firmware
UPC - 087944734307
View all IBM 8671 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
High-performance Ethernet modes Your Ethernet controller supports optional modes, such as teaming, priority packets, load balancing, fault tolerance, and virtual LANs, which provide higher performance, security, and throughput for your server. These modes apply to the integrated Ethernet controller and to the controllers on supported Ethernet adapters. Ethernet port connector The following illustration shows the pin-number assignments for the RJ-45 connector. These assignments apply to both 10BASE-T and 100/1000BASE-TX devices. 8 1 Updating the integrated system management firmware To update the integrated system management (ISM) firmware for the integrated system management processor (ISMP), download the Integrated System Management Firmware Update Utility program for your server from the IBM Support Web site at http://www.ibm.com/pc/support/. Then run the Integrated System Management Firmware Update Utility program to create a diskette to use to update the ISM firmware. This diskette updates the ISM firmware only and does not affect any device drivers. Complete the following steps to update the ISM firmware: 1. Turn off your server. 2. Insert the diskette into the diskette drive. 3. Turn on your server. If your server does not start from the diskette drive, use the Configuration/Setup Utility program to configure the diskette drive as a startup device. See "Using the Configuration/Setup Utility program" on page 15. Then, start again at step 1 4. From the main menu, select Update System Management Firmware and press Enter. 5. Follow the on-screen instructions to complete the update. If there is an error in updating the ISM firmware, try installing it again. Chapter 2. Configuration 27