IBM 8671 Hardware Maintenance Manual - Page 25
Configuration
![]() |
UPC - 087944734307
View all IBM 8671 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Chapter 2. Configuration The following configuration programs are provided with your server: v Configuration/Setup Utility This program is part of the basic input/output system (BIOS) code that comes with your server. You can use this program to configure serial and parallel port assignments, change interrupt request (IRQ) settings, change the drive startup sequence, set the date and time, and set passwords. You also can use this program to view the system configuration settings, for example, the number and type of installed microprocessors, the amount of installed memory, or the BIOS diagnostics version level. See "Using the Configuration/Setup Utility program" for more information. v LSI Logic Configuration Utility With the built-in LSI Logic Configuration Utility program, you can configure the integrated SCSI controller and the devices that are attached to it. See "Using the LSI Logic Configuration Utility program" on page 21. v ServeRAID Manager The ServeRAID programs come with your server. If your server has a ServeRAID controller installed, or if you are using the integrated SCSI controller with RAID capabilities as a RAID controller, you must use the ServeRAID Manager program to define and configure your disk-array subsystem before you install your operating system. See "Using ServeRAID Manager" on page 25 for more information. v ServerGuide Setup and Installation CD The ServerGuide Setup and Installation CD provides software setup tools and installation tools that are designed for your IBM server. Use this CD during the initial installation of your server to configure basic hardware features, such as an integrated SCSI controller with RAID capabilities, and to simplify your operating system installation. See "Using the ServerGuide Setup and Installation CD" on page 22. v Ethernet controller configuration process To configure the integrated Ethernet controller, see "Configuring the Gigabit Ethernet controller" on page 26. v Integrated System Management update and configuration To update the integrated system management (ISM) firmware, see "Updating the integrated system management firmware" on page 27. Using the Configuration/Setup Utility program This section provides instructions to start the Configuration/Setup Utility program and descriptions of the available menu choices. Starting the Configuration/Setup Utility program To start the Configuration/Setup Utility program: 1. Turn on the server and watch the monitor screen. 2. When the message Press F1 for Configuration/Setup appears, press F1. © Copyright IBM Corp. 2002 Note: If you have set both levels of passwords (power-on and administrator), you must type the administrator password to access the full Configuration/Setup Utility menu. Without the administrator password, limited Configuration/Setup Utility program functions are available. 15
![](/manual_guide/products/ibm-8671-hardware-maintenance-manual-61e0001/25.png)