IBM 8671 Hardware Maintenance Manual - Page 146
diagnostic
![]() |
UPC - 087944734307
View all IBM 8671 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 146 highlights
Note: See "System" on page 162 to determine which components should be replaced by a field service technician. Error code/symptom FRU/action 166-198-000 System Management: Aborted (Unable to communicate with ASM. It may be busy. Run the test again.) 1. Run the diagnostic test again. 2. Correct other error conditions and retry. These include other failed system management tests and items logged in the System Error Log of the optional Remote Supervisor Adapter. 3. Disconnect all server and option power cords from the server, wait 30 seconds, reconnect, and retry. 4. Remote Supervisor Adapter, if installed. 5. System board. 166-201-001 System Management: Failed 1. If installed, reseat the I2C cable between the Remote (I2C bus error(s) See SERVPROC and Supervisor Adapter (in PCI slot 1/J32) and the system board DIAGS entries in event log.) (J27). 2. Reseat memory DIMMs. 3. Memory DIMMs. 4. System board. 166-201-002 System Management: Failed 1. Reseat I2C cable between the operator information panel and (I2C bus error(s) See SERVPROC and the system board (J24). DIAGS entries in event log.) 2. Reseat I2C cable between the diagnostics panel and the system board (J23). 3. Operator information panel. 4. Diagnostics panel. 5. System board. 166-201-003 System Management: Failed 1. Reseat cables between the system board and the power supply (I2C bus error(s) See SERVPROC and or power cage assembly, if installed. DIAGS entries in event log.) 2. Power cage assembly, if installed. 3. System board. 166-201-004 System Management: Failed 1. DASD backplane (I2C bus error(s) See SERVPROC and DIAGS entries in event log.) 2. System board 166-201-005 System Management: Failed 1. Reseat Memory DIMMs. (I2C bus error(s) See SERVPROC and DIAGS entries in event log.) 2. Reseat microprocessors. 3. Memory DIMMs. 4. Microprocessors. 5. System board. 166-250-000 System Management: Failed 1. Reseat I2C cable between the Advanced System Management (I2C cable is disconnected. Reconnect I2C Adapter (in PCI slot 1/J32) and the system board (J27). cable between Remote Supervisor Adapter and system board.) 2. I2C cables. 3. Advanced System Management adapter. 4. System board. 166-260-000 System Management: Failed 1. Disconnect all server and option power cords from the server, (Restart ASM Error. After restarting, ASM wait 30 seconds, reconnect, and retry. communication was lost. Unplug and cold boot to reset ASM.) 2. Reseat the Remote Supervisor Adapter (in PCI slots 1/J32). 3. Remote Supervisor Adapter. 136 xSeries 235 Type 8671: Hardware Maintenance Manual and Troubleshooting Guide
![](/manual_guide/products/ibm-8671-hardware-maintenance-manual-61e0001/146.png)