IBM x3500 Installation Guide - Page 35
power-supply
UPC - 883436005760
View all IBM x3500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Positioning pins Transition duct DIMM air duct Plastic push pins Pin Rivet a. Remove the plastic push pins that secure the DIMM air duct to the power-supply cage. 1) Grasp the top of the plastic push pins and pull them out of the rivets. 2) Grasp the rivets and pull them out of the mounting holes and set them to the side. Note: If the DIMM air duct in your server is secured with screws, remove the screws. b. Push the air duct up toward the rear of the power-supply cage. When the locator pins are free of the power-supply cage, you can remove the air duct from the server. c. Position the transition duct so that the two tabs are directly over the slots on the side of the DIMM air duct. d. Slide the transition duct into the slots until it clicks into place. 9. Reinstall the DIMM air duct onto the power-supply cage. Chapter 2. Installing optional devices 21