Intermec PD41 PD41 and PD42 Commercial Printer User's Manual - Page 40
To con the IP settings serially using Fingerprint - default ip
View all Intermec PD41 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Chapter 2 - Connecting the Printer To configure the IP settings serially using Fingerprint 1 Connect the printer to your PC using a serial cable. For help, see "Connecting the Printer to a PC Through the Serial Port" on page 22. 2 Send the following commands to permanently assign the IP address, subnet mask, default router, and name server: setup "network,IP selection,manual" setup "network,IP address,xxx.xxx.xxx.xxx" setup "network,netmask,xxx.xxx.xxx.xxx" setup "network,default router,xxx.xxx.xxx.xxx" setup "network,nameserver,xxx.xxx.xxx.xxx" where xxx is a number from 0 to 255. 3 Disconnect the printer from the PC. 4 On your PC, enter the IP address of the printer in the address field of your web browser (for example http://10.200.27.94) and press Enter. The home page of the printer appears. To configure the IP settings serially using IPL 1 Connect the printer to your PC using a serial cable. For help, see "Connecting the Printer to a PC Through the Serial Port" on page 22. 2 Send the following commands to permanently assign the IP address, subnet mask, default router, and name server: nn[,m1[,m2]] where: n is the IP address of the printer in the format n.n.n.n, where n is a number from 0 to 255. ,m1 is the subnet mask address in the format n.n.n.n, where n is a number from 0 to 255. ,m2 is the router address in the format n.n.n.n, where n is a number from 0 to 255. Note: You must specify at least two of the three parameters for the command to take effect. 26 PD41 and PD42 Commercial Printer User's Manual