Intermec PD41 PD41 and PD42 Commercial Printer User's Manual - Page 48
To con the Printer to use WPA or WPA2 Enterprise mode
View all Intermec PD41 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Chapter 2 - Connecting the Printer To configure the Printer to use WPA or WPA2 Enterprise mode 1 Send the following commands to login as an admin and set the SSID: run"su-p pass admin" setup write "wlan","uart1:" setup "wlan","SSID","xxxxx" where xxxxx can be from 0 to 32 alphanumeric characters. 2 Send one of the following WPA/WPA2 ON commands to set up WPA-802.1x or WPA2-802.1x authentication. You should also send the WPA_PSK command that does not contain a value: setup "wlan","WPA","ON" setup "wlan","WPA2","ON" setup "wlan","WPA_PSK","" setup write "wlan","uart1:" • To view the 802.1x values, send this command: setup write "8021x","uart1:" 3 Send these commands to configure the EAP_TYPE: setup "8021x","EAP_TYPE","xxxx" where xxxx can be OFF, LEAP, PEAP, TTLS, or EAP-FAST. setup "8021x",".EAP_USER","xxxx" setup "8021x","EAP_PASS","xxxx" where xxxx is the unique username and the unique password for this protocol. 4 If you are using TTLS, you may need to send this command to set the TTLS outer name: setup "8021x","TTLS_USER","xxxx" where xxxx is the outer name. 5 If you are using EAP-FAST, you can use PAC and ACQUIRE_PAC commands. The PAC setting specifies the PAC file to use for EAPFAST authentication. The ACQUIRE_PAC setting checks to see if automatic PAC file provisioning is enabled. You can set ACQUIRE_PAC to on or off. • Send the following command to set PAC to use /tmp/my.pac with a pass phrase of "verysecret": setup "8021x","PAC","/tmp/my.pac @verysecret" 34 PD41 and PD42 Commercial Printer User's Manual