Intermec PD41 PD41 and PD42 Commercial Printer User's Manual - Page 81
Understanding Error Messages on the PD42, Possible PD42 Printer Error Icons and Messages
View all Intermec PD41 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Chapter 4 - Troubleshooting and Maintaining the Printer Understanding Error Messages on the PD42 Use the following tables to troubleshoot some common error messages you may see on the PD42 printer display. Some of the error messages are specific to the type of firmware you have loaded on your printer. Possible PD42 Printer Error Icons and Messages Error Icon Error Message Printhead lifted. Solution Lower printhead. Maintenance. The printer is upgrading its firmware. Wait for it to complete the task. IP link error. Check to see if the network cable has been unplugged. Press feed not done. Press Feed ( ) or Testfeed ( ). Test Label not taken. LSS too high, LSS too low. Printing has been stopped because a label is obstructing the label taken sensor. Remove the label to resume printing. Label stop sensor errors can occur when you perform a testfeed without any media installed or if you have incorrect media settings. To fix this error 1 Load the printer with media. For help, see "The printers can enter various states which indicate the current mode of operation." on page 9. 2 Restart the printer in Test mode and select the appropriate media type. For help, see "Using Testmode" on page 74. PD41 and PD42 Commercial Printer User's Manual 67