Kenmore 5044 Use and Care Guide - Page 29
Model, P1KB2/PIRFKB2, Capacity, Gallons, Liters, without, Filter, Indicator, Light
View all Kenmore 5044 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Base Grille Water Filtration System Model P1KB2/PIRFKB2 Capacity 200 Gallons (757 Liters) without Filter Indicator Light Chlorine Taste and Odor, Particulate Class I*; and against NSF/ANSI Standard 53 for the reduction of SLeyastde,mMetersctuerdy, aAntrdazcineert,ifiedBenzbeyneN,SFToInxtaeprnhaetnioen, al O-DagicahinlosrtobeNnSzeFn/AeN, SI CSytasntsd,ardTurb4i2ditfyo,r tAhsebersetdousc, tion of Lindane, Tetrachloroethylene, Endrin, Alachlor, Styrene, Chlorobenzene and Ethylbenzene. This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSl Standards 42 and 53. Substance Reduction Aesthetic Effects NSF Reduction Requirements Average Influent Influent Challenge Concentration Maximum Effluent Minimum % Reduction Average % Reduction Chlorine Taste/Odor Particulate Class I* Contaminant Reduction Lead: @ pH 6.5 Lead: @ pH 8.5 Mercury: @ pH 6.5 Mercury: @ pH 8.5 Benzene O-Dichlorobenzene Toxaphene Atrazine Asbestos Live Cysts _ Turbidity Alachlor Endrin Ethylbenzene Lindane Chlorobenzene Tetrachloroethylene Styrene 50% reduction 85% reduction NSF Reduction Requirements 0.010 mg/L 0.010 mg/L 0.002 mg/L 0.002 mg/L 0.005 mg/L 0.6 mg/L 0.003 mg/L 0.003 mg/L 99% >99.95% 0.5 NTU 0.002 mg/L 0.002 mg/L 0.7 mg/L 0.0002 mg/L 0.1 mg/L 0.005 mg/L 0.1 mg/L 2.10 mg/L 21000000#/mL Average Influent 150 ug/L 160 ug/L 5.8 ug/L 6.1 ug/L 15 ug/L 1900 ug/L 14 ug/L 9.0 ug/L 130 MFL 96,000/L 12 NTU 41 ug/L 5.9 ug/L 2100 ug/L 1.9 ug/L 2100 ug/L 14 ug/L 2200 ug/L 2.0 mg/L + 10% At least 10,000 particles/mL Influent Challenge Concentration 0.15 mg/L + 10% 0.15 mg/L _+10% 0.006 mg/L + 10% 0.006 mg/L _+10% 0.015 mg/L _+10% 1.8 mg/L _+10% 0.015 mg/L _+10% 0.009 mg/L _+10% 107to 108fibers/U t 50,000/L min. 11 _+1 NTU 0.04 mg/L _+10% 0.006 mg/L _+10% 2.1 mg/L _+10% 0.002 mg/L _+10% 2.0 mg/L _+10% 0.015 mg/L _+10% 2.0 mg/L _+10% 0.05 mg/L ** 140000 #/mL Maximum Effluent 1.0 ug/L 2.0 ug/L 0.3 ug/L 0.4 ug/L 0.5 ug/L 0.7 ug/L 1.0 ug/L 0.5 ug/L 0.17 MFL 1/U 0.4 NTU 1.0 ug/L 0.2 ug/L 0.5 ug/L 0.02 ug/L 1.1 ug/L 0.5 ug/L ND (0.5) 97.6 99 Minimum % Reduction 99.3 98.7 94.9 93.4 96.7 99.9 91.5 94.5 99 99.99 96.7 97.6 96.5 99.9 99 99.9 96 99.9 97.6 99.5 Average % Reduction 99.3 99.3 96.6 95.3 96.7 99.9 92.8 94.5 99 99.99 98.5 97.6 96.6 99.9 99 99.9 96.4 99.9 Test Parameters: pH = 7.5 _+0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 200 gallons (757 liters). • It is essential that operational, maintenance, and filter replacement requirements be carried out for the product to perform as advertised. • Model PIKB2: Change the water filter cartridge every 6 months. If the water flow to the water dispenser or ice maker decreases noticeably before 6 months have passed, replace the water filter cartridge more often. Use replacement cartridge P1 RFKB2, part #9030. 2008 suggested retail price of $59.99 U.S.A./S71.99 Prices are subject to change without notice. Canada. • These contaminants are not necessarily in your water supply. While testing was performed under standard laboratory conditions, actual performance may vary. • The product is for cold water use only. • Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. • Refer to the "Warranty" section for the Manufacturer's name, address and telephone number. • Refer to the "Warranty" section for the Manufacturer's limited warranty. Application Water Supply Water Pressure Water Temperature Guidelines/Water Supply Parameters City or Well 30 - 120 psi (207 - 827 kPa) 33 ° - 100°F (0.6 ° - 37.8°C) Service Flow Rate 0.5 gpm (1.9 L/min) @ 60 psi *Class I particle size: >0.5 to