Kenmore 5044 Use and Care Guide - Page 30
Model, PIKB1/PIRFKB1, Capacity, Gallons, Liters
View all Kenmore 5044 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Base Grille Water Filtration System Model PIKB1/PIRFKB1 Capacity 100 Gallons (379 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor, Particulate Class I*; and against NSF/ANSI Standard 53 for the reduction of Lead, Mercury, Atrazine, Benzene, Toxaphene, O-Dichlorobenzene, Cysts, Turbidity, Asbestos, Lindane, Tetrachloroethylene, Endrin, Alachlor, Styrene, Chlorobenzene, Ethylbenzene, TTHM, MTBE and VOC. This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSl Standards 42 and 53. Substance Reduction Aesthetic Effects Chlorine Taste/Odor Particulate Class I* Contaminant Reduction Lead: @ pH 6.5 Lead: @ pH 8.5 Mercury: @ pH 6.5 Mercury: @ pH 8.5 Benzene O-Dichlorobenzene Toxaphene Atrazine Asbestos Live Cysts _ Turbidity Alachlor Endrin Ethylbenzene Lindane Chlorobenzene Tetrachloroethylene Styrene TTH M MTBE VOC NSF Reduction Requirements 50% reduction 85% reduction NSF Reduction Requirements 0.010 mg/L 0.010 mg/L 0.002 mg/L 0.002 mg/L 0.005 mg/L 0.6 mg/L 0.003 mg/L 0.003 mg/L 99% >99.95% 0.5 NTU 0.002 mg/L 0.002 mg/L 0.7 mg/L 0.0002 mg/L 0.1 mg/L 0.005 mg/L 0.1 mg/L 0.080 mg/L 0.005 mg/L 0.05 mg/L Average Influent 2.10 mg/L 21000000#/m L Average Influent 150 ug/L 160 ug/L 5.8 ug/L 6.1 ug/L 15 ug/L 1900 ug/L 14 ug/L 9.0 ug/L 130 MFL 96,000/L 12 NTU 41 ug/L 5.9 ug/L 2100 ug/L 1.9 ug/L 2100 ug/L 14 ug/L 2200 ug/L 480 ug/L 15 ug/L 300 ug/L Influent Challenge Concentration 2.0 mg/L + 10% At east 10,000 part c es/mL Influent Challenge Concentration 0.15 mg/L + 10% 0.15 mg/L_+ 10% 0.006 mg/L + 10% 0.006 mg/L _+10% 0.015 mg/L_+ 10% 1.8 mg/L _+10% 0.015 mg/L_+ 10% 0.009 mg/L _+10% 107to 108fibers/l_ tt 50,000/L min. 11 _+1 NTU 0.04 mg/L _+10% 0.006 mg/L _+10% 2.1 mg/L_+ 10% 0.002 mg/L _+10% 2.0 mg/L _+10% 0.015 mg/L_+ 10% 2.0 mg/L _+10% 0.45 + 20% 0.015 _+20% 300 _+30 ug/L Maximum Effluent 0.05 mg/L ** 140000 #/mL Maximum Effluent 1.0 ug/L 2.0 ug/L 0.2 ug/L 0.4 ug/L 0.5 ug/L 0.7 ug/L 1.0 ug/L 0.5 ug/L 0.17 MFL 1/U 0.4 NTU 1.0 ug/L 0.2 ug/L 0.5 ug/L 0.02 ug/L 1.1 ug/L 0.5 ug/L ND (0.5) 3.9 ug/L 1.3 ug/L aD (0.5) Minimum % Reduction 97.6 99 Minimum % Reduction 99.3 99.4 96.6 93.4 96.7 99.9 91.5 94.5 99 99.99 96.7 97.6 96.5 99.9 99 99.9 96 99.9 99.2 91.3 99.8 Average % Reduction 97.6 99.5 Average % Reduction 99.3 99.3 96.6 95.3 96.7 99.9 92.8 94.5 99 99.99 98.5 97.6 96.6 99.9 99 99.9 96.4 99.9 99.8 96.2 99.8 Test Parameters: pH = 7.5 _+0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 100 gallons (379 liters). • It is essential that operational, maintenance, and filter replacement requirements be carried out for the product to perform as advertised. • Model PIKBI" The filter monitor system measures the amount of water that passes through the filter and alerts you to replace the filter. • Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. Refer to the "Warranty" section for the Manufacturer's name, address and telephone number. Style 1 - When the filter indicator reads 10%, order a new filter. When the indicator reads 0%, it is recommended that you replace the filter. Refer to the "Warranty" section for the Manufacturer's limited warranty. Style 2 - When the filter indicator changes from green to yellow, order a new filter. When the indicator changes from yellow to red, it is recommended that you replace the filter. Style 3 - When the water filter status display changes from "GOOD" to "ORDER," order a new filter. When the filter indicator reads "REPLACE," it is recommended that you replace the filter. Use replacement cartridge P1 RFKB1, part #9030. 2008 suggested retail price of $59.99 U.S.A./S71.99 Prices are subject to change without notice. Canada. Application Guidelines/Water Supply Parameters Water Supply Water Pressure Water Temperature Service Flow Rate City or Well 30 - 120 psi (207 - 827 kPa) 33 ° - 100°F (0.6 ° - 37.8°C) 0.5 gpm (1.9 L/min) @ 60 psi • These contaminants are not necessarily in your water supply. While testing was performed under standard laboratory conditions, actual performance may vary. • The product is for cold water use only. *Class I particle size: >0.5 to