Kyocera KM-C2230 Fiery X3e 22C-KM Configuration Guide for KM-C2230 - Page 76

44-20 Performing Setup from the Control Panel For protocols other than IPX/SPX, the frame type is automatically enabled and does not require setup, as follows: With this protocol And these printing services This frame type is automatically enabled AppleTalk TCP/IP with Ethernet PAP (Printer Access Protocol) LPD (Line Printer Daemon) Ethernet SNAP Ethernet II Select Frame Types Enable IPX Auto Frame Type Yes/No [No] Specify whether the Fiery X3e should try to bind to all available frame types automatically. The Fiery X3e does so whether or not all frame types are appropriate. To determine the frame types that were successfully bound, save your changes, exit Setup, restart the Fiery X3e, and print a Configuration page. The Configuration page lists only one of the frame types that were successfully bound. If you answer No to this option, you can select frame types manually. You must choose at least one frame type to enable IPX/SPX protocols. The frame selection screen allows you to make multiple selections. Depending on your Port Setup selection, only Ethernet frame types or all frame types are displayed. Press OK (copier) or Set (printer) for each frame type used on your IPX/SPX network. An asterisk (*) appears beside each selected frame type. Press the line selection button again to cancel a selected frame type. Use the up and down arrow buttons to scroll to additional frame types. The Fiery X3e binds to each frame type as you select it. When you have selected all the frame types used, choose Exit IPX/SPX Setup. Clear Frame Types You can clear all frame types at once by choosing Exit IPX/SPX Setup, choosing IPX/SPX Setup, and then choosing Clear Frame Types.