Lantronix XPort XChip - User Guide - Page 53
Send the Escape Sequence (+++) in Modem Mode, XPort User Guide
View all Lantronix XPort manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
7: Setup Mode: Channel Configuration If this sequence is not followed, the unit remains in data transfer mode. Modem Mode Command ATDTx.x.x.x,pppp, ATDTx.x.x.x/pppp, or ATDTx.x.x.x:pppp Table 7-11. Modem Mode Commands Function Makes a connection to an IP address (x.x.x.x) and a remote port number (pppp). ATDTx.x.x.x Makes a connection to an IP address (x.x.x.x) and the remote port number defined within the unit. ATD0.0.0.0 Forces the unit into Monitor Mode if a remote IP address and port number are defined within the unit. ATD or ATDT Forces the unit into Monitor Mode if a remote IP address and port number are not defined within the unit. ATDx.x.x.x Makes a connection to an IP address (x.x.x.x) and the remote port number defined within the unit. ATH ATS0=n Hangs up the connection (Entered as +++ATH ). Enables or disables connections from the network going to the serial port. n=0 disables the ability to make a connection from the network to the serial port. n=1-9 enables the ability to make a connection from the network to the serial port. ATEn ATVn n>1-9 is invalid. Enables or disables character echo and responses. n=0 disables character echo and responses. n=1 enables character echo and responses. Enables numeric response or full verbose. n=0 enables numeric response. n=1 enables full verbose. Note: The unit recognizes these AT commands as single commands such as ATE0 or ATV1; it does not recognize compound commands such as ATE0V. Send the Escape Sequence (+++) in Modem Mode Send '+++' in Modem Mode (Y) ? _ XPort User Guide 53