Netgear WAC730-Business User Manual - Page 10
Rear Panel, Table 1.Top panel LEDs, Introduction and Hardware Overview
View all Netgear WAC730-Business manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Dual-Band Wireless AC Access Point WAC720 and WAC730 User Manual Table 1. Top panel LEDs Item LED 1 2 Description Power/Test Off On (green) Amber, then blinking green Active Off On or blinking (green) Power is off. Power is on. A self-test is running or firmware is being loaded. During startup, the LED is first steady amber, then goes off, and then blinks green before turning steady green after about 45 seconds. If after one minute the LED remains amber or continues to blink green, it indicates a system fault. No Ethernet traffic is detected, or no link is detected. Ethernet traffic is detected. 3 LAN Off Amber Green A 10 Mbps or no link is detected on LAN port. A 100 Mbps link is detected on LAN port. A 1000 Mbps link is detected on LAN port. 4 2.4 GHz Off WLAN The WiFi 802.11b/g/n (2.4 GHz) LAN is not ready, or no WiFi activity is detected. On or blinking (green) The WiFi 802.11b/g/n (2.4 GHz) LAN is ready, or WiFi activity is detected. 5 5 GHz Off WLAN The WiFi 802.11n/a (5 GHz) LAN is not ready, or no WiFi activity is detected. On or blinking (green) The WiFi 802.11n/a (5 GHz) LAN is ready, or WiFi activity is detected. Rear Panel Figure 2. Rear panel Introduction and Hardware Overview 10