Panasonic D10000U Operating Instructions - Page 111
Information, Procedure of, lamp unit replacement
UPC - 791871111413
View all Panasonic D10000U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
Procedure of lamp unit replacement 1. Be sure to observe the procedure "Powering up the projector" (p. 35) and "Powering off the projector" (p. 36), remove the power plug and confirm that the surroundings of the lamp unit have cooled off. 2. Use a Phillips screwdriver to loosen the lamp unit cover screw at the rear of the projector until the screw turns freely. 3. Open the lamp unit cover and remove it from the projector. Lamp unit cover screw 4. Use a Phillips screwdriver to loosen the three fixing screws for the lamp unit to be replaced until the screws turn freely. Hold the handle of the lamp unit and gently pull the lamp unit out from the projector. Lamp unit cover Fixing screws CAUTION The lamp unit and structural parts around the lamp unit will be hot immediately after the projector has been used. You might get burned if you touch it while it is still hot. Lamp unit 2 Lamp unit 1 Handle Lamp unit 3 Lamp unit 4 5. Install the new lamp unit. 6. Use a Phillips screwdriver to securely tighten the 3 lamp unit fixing screws for each lamp unit. 7. Install and close the lamp unit cover, and then use a Phillips screwdriver to securely tighten the lamp unit cover screw. Lamp unit cover screw Caution • Firmly install the lamp unit and lamp unit cover. If not installed firmly, a protection circuit will function and the power will not be turned on. Lamp unit cover Information ENGLISH - 111