Panasonic D10000U Operating Instructions - Page 81

Note • The air filter cleaning monitor (FILTER CLEANING) will flash blue while cleaning of the air filter is in progress. If there is a problem with the air filter, the air filter cleaning monitor (FILTER CLEANING) will light red. • The time taken for cleaning is approximately 30 to 40 seconds. • The setting time will be the local time. p. 81 • Automatic cleaning will not be carried out if the projector is in standby mode. • If the projector is not in projection mode when the setting time is reached, automatic cleaning will not be carried out. • Automatic cleaning will not be carried out if 24 hours have not yet elapsed since cleaning was last carried out (either by automatic cleaning or forced cleaning). Example: If the setting time is 7:00 and forced cleaning is carried out at 9:00, then automatic cleaning will not be carried out at 7:00 on the following day. 46 hours elapsed 22 hours elapsed Setting time Setting time Setting time Automatic Forced (No cleaning) cleaning cleaning Automatic cleaning • If the time is set to a time which is within 24 hours from the last time cleaning was carried out, automatic cleaning will not be carried out the next time the setting time is reached. Instead, cleaning will be carried out when the setting time is reached on the following day. Example: If cleaning was carried out at 10:00, and the cleaning time setting is then changed to 20:00, automatic cleaning will be carried out at 20:00 on the following day. 34 hours elapsed 10 hours elapsed Setting time Setting time Setting time Automatic cleaning (No cleaning) Time reset Automatic cleaning • When projection starts (when the power is turned on), automatic cleaning will be carried out immediately if more than 24 hours have elapsed since cleaning was last carried out. Setting the date and time This lets you set the time zone and the current date and time for the projector's internal clock. 1. Press ▲▼ to select "DATE AND TIME". OPTION2 PROJECTOR ID INSTALLATION ALTITUDE DIRECTION LAMP SELECT LAMP RELAY RS-232C SYSTEM INFORMATION AIR FILTER CLEANING DATE AND TIME STARTUP LOGO PASSWORD MENU SELECT ENTER SUB MENU 2 FRONT-F LOW H QUAD OFF LOGO1 2. Press ENTER. • The "DATE AND TIME" screen will be displayed. DATE AND TIME TIME ZONE ADJUST CLOCK LOCAL DATE LOCAL TIME MENU SELECT CHANGE 09:00 2007/01/01 12:34:56 3. Press ▲▼ to select "TIME ZONE". 4. Press ◄► to switch "TIME ZONE". 5. Press ▲▼ to select "ADJUST CLOCK". 6. Press ENTER. • The "ADJUST CLOCK" screen will be displayed. ADJUST CLOCK YEAR MONTH DAY HOUR MINUTE APPLY MENU SELECT CHANGE 2007 1 1 12 34 7. Press ▲▼ to select the item to be set, and use ◄► to set the local time. 8. Use ▲▼ to select "APPLY", and then press ENTER. • This completes setting of the time. ENGLISH - 81 Special Features