Pioneer AVIC-X910BT Owner's Manual - Page 165

Customizing preferences Chapter 25 Customizing preferences ! ATT - Attenuation ! Normal - Volume does not change p Operation returns to normal when the cor- respond action is ended. p When "SD" or "USB" selected as the AV source, the sounds are not muted or attenuated even when the navigation guidance and beep outputs. p When "SD" or "USB" is selected as the AV source, the AV sounds, the navigation guidance and beep sounds are mixed and the volume can be adjusted simultaneously. Important Notice regarding Volume of Navigation Voice Guidance when Playing Audio Files from USB or SD If music files stored on an external storage device (USB, SD) are played when the system guides the route (i.e., a destination has been selected and the system is routing you to a destination), the volume of the navigation guidance voice will be the same as the volume of the music files being played, even if a different volume level has been selected on "Master" or "Voice" or "Dynamic Volume" in the "Sound settings" menu. Setting the rear output The navigation system's rear output can be used for a full-range speaker or subwoofer connection. If you switch Rear SP to Sub W, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp. Initially, the navigation system is set for a rear full-range speaker connection (Full). 1 Touch [Rear SP] on the "AV System Settings" menu. = For details, refer to Displaying the "AV System Settings" menu on page 163. 2 Touch [Rear SP] to switch the rear output setting. When no subwoofer is connected to the rear output, select Full. When a subwoofer is connected to the rear output, select Sub W. p Both rear speaker leads output and RCA rear output are switched simultaneously in this setting. (When you use the product without RCA rear output, this setting only applies to the rear speaker leads.) Acquiring/Cataloging iPod music information If you always set the language other than "English" on "Program language:", this setting is unnecessary. Unless [VR Catalog Mode] is turned off, this navigation system tries to acquire the information needed to operate iPod with voice commands. It may take a short period of time to transfer the information. Change the setting according to your usage. The navigation system starts acquiring/cataloging music information (1) when the iPod is connected or when the system boots up while the iPod is connected and (2) when iPod is the selected and displayed AV Source, unless [VR Catalog Mode] is turned off. p If you do not use iPod, this setting is un- necessary. p During transfer, iPod operations (such as [Shuffle], [Menu], or [Video]) are not available. p Once the cataloging is completed, you can deactivate [VR Catalog Mode] until you update the content/data on iPod. If you update the iPod data, activate [VR Catalog Mode] again to transfer the music information and synchronize the music information for voice commands with the data on iPod. p After you select "Off" in [VR Catalog Mode], the system doesn't catalog the data on the iPod. In such case, the previously cataloged data are available as voice commands. En 165