TP-Link T1700G-28TQ T1700G-28TQ V1 CLI Reference Guide - Page 157
storm-control pps, storm-control
View all TP-Link T1700G-28TQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 157 highlights
20.11 storm-control pps Description The storm-control pps command is used to configure the storm control mode as pps(packets per second) on an interface. To disable the pps mode, please use no storm-control pps command. Syntax storm-control pps no storm-control pps Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet / interface ten-gigabitEthernet / interface range ten-gigabitEthernet / interface port-channel / interface range port-channel) User Guidelines This command should be used along with the storm-control command to enable the storm control function and specify the detailed parameters in pps mode. Example Set the storm control mode as pps on port 1/0/5: T1700G-28TQ(config)# interface gigabitEthernet 1/0/5 T1700G-28TQ(config-if)# storm-control pps 20.12 storm-control Description The storm-control command is used to enable the broadcast, multicast, or unicast strom control function and to set threshold levels on an interface. To disable the storm control function, please use no storm-control command. Syntax storm-control { broadcast | multicast | unicast } { kbps | ratio | pps } { rate } no storm-control { broadcast | multicast | unicast } Parameter broadcast | multicast | unicast -- Enable broadcast/multicast/unicast storm control on the interface. kbps | ratio | pps -- Specify the storm control type. kbps: Specify the threshold in kbits per second. 143