TP-Link T1700G-28TQ T1700G-28TQ V1 CLI Reference Guide - Page 247
snmp-server traps link-status, snmp-server traps
View all TP-Link T1700G-28TQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 247 highlights
29.9 snmp-server traps link-status Description The snmp-server traps link-status command is used to enable SNMP link status trap for the specified port. To disable the sending of SNMP link status trap, please use no snmp-server traps link-status command. Syntax snmp-server traps link-status no snmp-server traps link-status Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet / interface ten-gigabitEthernet / interface range ten-gigabitEthernet) Example Enable SNMP link status trap for port 1/0/3: T1700G-28TQ(config)# interface gigabitEthernet 1/0/3 T1700G-28TQ(config-if)# snmp-server traps link-status 29.10 snmp-server traps Description The snmp-server traps command is used to enable SNMP extended traps. To disable the sending of SNMP extended traps, please use no snmp-server traps command. Syntax snmp-server traps { bandwidth-control | cpu | flash | loopback-detection | storm-control | spanning-tree | memory } no snmp-server traps { bandwidth-control | cpu | flash | loopback-detection | storm-control | spanning-tree | memory } Parameter bandwidth-control -- Enable bandwidth-control trap. It is sent when the rate limit function is enabled and the bandwidth exceeds the predefined value. cpu -- Allow CPU-related trap. It is sent when CPU usage exceeds the predefined threshold. By default, the CPU usage threshold of the switch is 80%. 233