TP-Link T1700G-28TQ T1700G-28TQ V1 CLI Reference Guide - Page 231
ipv6 mld snooping max-groups
View all TP-Link T1700G-28TQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 231 highlights
ip-addr -- The source IP of the general query frame sent by MLD Snooping Querier. It should not be a multicast IP or a broadcast IP. By default, it is fe80::02ff:ffff:fe00:0001. Command Mode Global Configuration Mode Example For VLAN 2, specify its query-interval as 200 seconds, and the response-time as 20 seconds: T1700G-28TQ(config)#ipv6 mld snooping querier vlan 2 query-interval 200 T1700G-28TQ(config)#ipv6 mld snooping querier vlan 2 max-response-time 20 28.14 ipv6 mld snooping max-groups Description The ipv6 mld snooping max-groups command is used to configure the maximum number of groups that a port can join in. The ipv6 mld snooping max-groups action is used to configure the action that the port takes when it receives an MLD report message and the maximum number of entries is in the forwarding table. To remove the maximum group limitation and return to the default of no limitation on the specified port, please use the no ipv6 mld snooping max-groups command. To return to the default action of dropping the report, please use the no ipv6 mld snooping max-groups action command. These commands only apply to the dynamic multicast groups. Syntax ipv6 mld snooping max-groups [ maxgroup ] ipv6 mld snooping max-groups action { drop | replace } no ipv6 mld snooping max-groups no ipv6 mld snooping max-groups action Parameter maxgroup -- Specify the maximum numbers of groups that the port can join. It ranges from 0 to 1000 and the default value is 1000. drop -- When the number of the dynamic multicast groups that a port joins has exceeded the max-group, the port will not join any new multicast group. 217