TP-Link T1700G-28TQ T1700G-28TQ V1 CLI Reference Guide - Page 158
bandwidth
View all TP-Link T1700G-28TQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
ratio: Specify the threshold as a percentage of the bandwidth. pps: Specify the threshold in packets per second. rate -- Specify the bandwidth for receiving packets on the port. The specified type of packet traffic exceeding the bandwidth will be discarded. For kbps, the rate ranges from 1 to 10000000 kbps. For ratio, the rate ranges from 1 to 100 percent. For pps, the rate ranges from 1 to 1488000 packets per second. Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet / interface ten-gigabitEthernet / interface range ten-gigabitEthernet / interface port-channel / interface range port-channel) User Guidelines Before you configure the storm-control type as kbps or ratio, pelease ensure that the port is not in pps mode. Example Configure the broadcast storm control rate as 1000 kbps on port 1/0/5: T1700G-28TQ(config)# interface gigabitEthernet 1/0/5 T1700G-28TQ(config-if)# storm-control broadcast kbps 1000 20.13 bandwidth Description The bandwidth command is used to configure the bandwidth limit for an Ethernet port. To disable the bandwidth limit, please use no bandwidth command. Syntax bandwidth {[ ingress ingress-rate ] [ egress egress-rate ]} no bandwidth { all | ingress | egress } Parameter ingress-rate -- Specify the bandwidth for receiving packets. Range: 1-1000000Kbps for the gigaport, 1 to 10000000 kbps for the ten-gigabit port. egress-rate -- Specify the bandwidth for sending packets. Range: 1-1000000Kbps for the gigaport, 1 to 10000000 kbps for the ten-gigabit port. Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet / interface ten-gigabitEthernet / interface range ten-gigabitEthernet / interface port-channel / interface range port-channel) 144