TP-Link T1700G-28TQ T1700G-28TQ V1 CLI Reference Guide - Page 98

Parameter level -- Severity level of the log message. There are 8 severity levels marked with values 0-7. The smaller value has the higher priority. Only the log with the same or smaller severity level value will be saved to the flash. By default, it is 3 indicating that the log message marked with 0~3 will be saved in the log flash. Command Mode Global Configuration Mode Example Save the log messages with their severities equal or higher than 7 to the flash : T1700G-28TQ(config)#logging file flash level 7 14.6 logging host index Description The logging host index command is used to configure the Log Host. To clear the configuration of the specified Log Host, please use no logging host index command. Log Host is to receive the system log from other devices. You can remotely monitor the settings and operation status of other devices through the log host. Syntax logging host index idx host-ip level no logging host index idx Parameter idx -- The index of the log host. The switch supports 4 log hosts at most. host-ip -- The IP for the log host. level -- The severity level of the log information sent to each log host. There are 8 severity levels marked with values 0-7. The smaller value has the higher priority. Only the log with the same or smaller severity level value will be sent to the corresponding log host. By default, it is 6 indicating that the log information marked with 0~6 will be sent to the log host. Command Mode Global Configuration Mode 84