TP-Link T1700G-28TQ T1700G-28TQ V1 CLI Reference Guide - Page 67
telnet
View all TP-Link T1700G-28TQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
access the switch. To cancel the user access limit, please use no user access-control command. Syntax user access-control port-based interface { gigabitEthernet port | ten-gigabitEthernet port } [ snmp ] [ telnet ] [ ssh ] [ http ] [ https ] [ ping ] [ all ] no user access-control Parameter port -- The Ethernet port number. port-list --The list group of Ethernet ports, in the format of 1/0/1-4. You can appoint 5 ports at most. [ snmp ] [ telnet ] [ ssh ] [ http ] [ https ] [ ping ] [ all ] -- Specify the access interface. These interfaces are enabled by default. Command Mode Global Configuration Mode Example Configure that only the users connected to ports 1/0/2-6 are allowed to access the switch: T1700G-28TQ(config)# user access-control port-based interface range gigabitEthernet 1/0/2-6 9.6 telnet Description The telnet enable command is used to enable the Telnet function. To disable the Telnet function, please use the telnet disable command. This function is enabled by default. Syntax telnet enable telnet disable Command Mode Global Configuration Mode Example Disable the Telnet function: 53