Thermador ME301YP Instructions for Use - Page 32

en-us Eliminating faults Fault Oven is not self-cleaning properly Clock and timer are not working properly "E" and a number appears in display and control beeps With a new oven there is a strong odor when oven is turned on Control does not react when a key is touched Warm air or steam escapes from oven vent Cooling fan runs even when the oven is turned off Cause The oven is too hot to start self clean There is no power supply to the appliance An electronics fault has occured This is normal with a new oven and will disappear after a few uses The control is wet or soiled The buttons are not pressed correctly It is normal to see or feel steam or warm air escaping from the oven vent The cooling fan will continue to run, even after the oven has been turned off, until the oven has cooled sufficiently Troubleshooting 1. Allow the oven to cool before running self clean. 2. Always wipe out loose soils or heavy spillovers before running self clean. 3. If the oven is heavily soiled, set the maximum self clean time. 1. Check circuit breaker or fuse box to your house. 2. Make sure there is proper electrical power to the oven. 1. Press any key to stop the beeping. 2. Reset the oven if necessary. 3. Call an authorized service provider. ▶ Operate the self clean mode to burn-off the smell more quickly. ▶ Clean the control panel an wipe it dry. 1. Press the center of the button. 2. Use the flat part of your finger. CAUTION Risk of fire! The oven vents are important for air circulation. Covering the oven vents will cause the oven to overheat. Refer to the appliance overview for the location of the oven vents. → "Familiarizing yourself with your appliance", Page 11 ▶ Do not obstruct oven vents. ▶ This is normal. There is no action required. 32