Thermador PRG366WH Instructions for Use - Page 31
Cleaning the appliance, Replacing the oven light bulb, CAUTION, DO NOT USE CHLORINE BASED CLEANERS
View all Thermador PRG366WH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
• If the user tries to enable a self-clean function in an oven where the self-clean function has been restricted, the oven lights will blink on and off in 2second intervals to indicate to the user that the function is not available. User must turn the knobs to OFF to cease the blinking lights. Cleaning the appliance 9 CAUTION Avoid cleaning any part of the range while it is hot. • The porcelain enamel finish is acid resistant, but not acid proof. Acidic foods, such as citrus juices, tomatoes, rhubarb, vinegar, alcohol or milk, should be wiped up and not allowed to bake onto the porcelain during the next use. • Use the mildest cleaning procedure that will do the job efficiently and effectively. Some cleaners of the same type are harsher than others. Try on a small inconspicuous area first. • Always rub metal finishes in the direction of the polish lines for maximum effectiveness and to avoid marring the surface. • Use only clean soft cloths, sponges, paper towels, fibrous brushes, plastic, non-metal or steel wool soap pads for cleaning and scouring, as recommended on the chart. • Most exterior parts of this appliance can be cleaned with hot sudsy water (except the various items specifically identified otherwise). When rinsing is required, rinse thoroughly. • Always wipe dry immediately to avoid water marks. • DO NOT USE CHLORINE BASED CLEANERS. Replacing the oven light bulb 9 CAUTION The light socket is live when the door is open. Make sure the appliance and lights are cool and power to the appliance has been turned off before replacing the light bulb(s). Failure to do so could result in electrical shock or burns. The covers must be in place when using the appliance. Use only 10W, 12V G4 light bulbs. Use a clean, dry cloth to handle the light bulbs. This will increase the life of the bulb. Replacing the light bulb 1. Turn off circuit breaker. 2. Remove the oven racks. 3. Slide the tip of a flat blade screw driver between the holder clip and the lamp housing (figure, a). 4. Support the glass lens cover with fingers along the bottom edge to prevent the cover from falling to the bottom of the oven. Gently twist the flat blade screw driver to loosen the glass lens cover. 5. Remove the glass lens cover. 6. Remove the bulb by grasping and sliding the bulb straight back until the two prongs have cleared the ceramic holder (figure, b). 7. DO NOT touch the glass of the new replacement bulb with your fingers. It may cause the bulb to fail when it first lights. Grasp the replacement bulb with a clean dry cloth. Locate the two prongs in the ceramic holder, gently poking until the two prongs locate in the ceramic socket. 8. Press down to seat the bulb (figure, c). 9. Slide the protective lens into the holder clip and push the other end until the fixing clip snaps back into the housing (figure, d). a b c d 10. Turn on circuit breaker. 29