Thermador PRG366WH Instructions for Use - Page 8

9 IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS WARNING-DANGER OF TIPPING ON RANGES • All ranges can tip and injury can result. To prevent accidental tipping of the range, attach it to the floor, wall, or cabinet by installing the anti-tip bracket supplied. • A child or adult can tip the range over and be killed or seriously injured. Verify that the anti-tip bracket is securely installed. Ensure the anti-tip bracket is engaged when the range is moved. • DO NOT operate the range without the anti-tip bracket in place. Failure to follow the instructions in this manual can result in death or serious burns to children and adults. • If the range is pulled away from the wall for cleaning, service, or any other reason, ensure that the anti-tip bracket is properly reengaged when the range is pushed back into place. In the event of abnormal usage (such as a person standing, sitting, or leaning on an open door), failure to take this precaution can result in tipping of the range. Personal injury might result from spilled hot liquids or from the range itself. • Check for proper installation and use of anti-tip bracket. Carefully tip range forward pulling from the back to ensure that the anti-tip bracket engages the range and prevents tip-over. Range should not move more than 1'' (2.5 cm). REQUIREMENTS AND STANDARDS • The appliance must be electrically grounded in accordance with local codes or, in the absence of local codes, with the with the National Electrical Code, NFPA 70 or the Canadian Electrical Code, CSA C22.1. • Installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54 or, in Canada, the Natural Gas and Propane Installation Code, CSA B149.1. • Installation of appliances designed for manufactured (mobile) home installation must conform with the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 [formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD (Part 280)] or with local codes where applicable. • Installation of appliances designed for recreational park trailers must conform with state or other codes or, in the absence of such codes, with the ANSI A119.5 Park Model Recreational Vehicle Standard. • See the Installation Instructions for electrical requirements, grounding instructions and clearance to combustible material requirements. • Service should only be done by an authorized service provider. • It is the responsibility of the owner and the installer to determine if additional requirements and/or standards apply to specific installations. GAS REQUIREMENTS • A manual valve must be installed in an accessible location in the gas piping external to the appliance for the purpose of turning on or shutting off gas to the appliance. • In the event a burner goes out and gas escapes, open a window or a door. DO NOT attempt to use the appliance until the gas has had time to dissipate. Wait at least 5 minutes before using the appliance. • For Massachusetts installations: • Installation must be performed by a qualified or licensed contractor, plumber or gas fitter qualified or licensed by the state, province or region where this appliance is being installed. • Shut-off valve must be a "T" handle gas cock. • Flexible gas connector must not be longer than 36'' (914 mm). • The maximum depth of cabinets installed above cooking surface must be 13'' (330 mm). • Natural gas - 7 in. w.c. (17.4 mbar) minimum, 14 in. (34.9 mbar) maximum • Propane gas - 11 in. w.c. (27.4 mbar) minimum, 14 in. (34.9 mbar) maximum PROPOSITION 65 WARNING This product may contain a chemical known to the State of California, which can cause cancer or reproductive harm. Therefore, the packaging of your product may bear the following label as required by California: State of California Proposition 65 Warning: : WARNING Cancer and Reproductive Harm www.P65Warnings.ca.gov Disposal of packaging The packaging materials are environmentally compatible and can be recycled. Sort the individual components by type and dispose of them separately. Information about current disposal methods can be obtained from your specialist dealer or local authority. 6