Xerox PE120 User Guide - Page 276

Symptom Problems with feeding Problem with Paper Ragged edges Solution Use good quality paper. NOTES: • Do not use letterhead paper printed with low-temperature inks, such as those used in some types of thermography. • Do not use raised or embossed letterhead. • The machine uses heat and pressure to fuse toner to the paper. Insure that any colored paper or preprinted forms use inks that are compatible with this fusing temperature (200 °C or 392 °F for 0.1 second). Paper Specifications Category Acid content Caliper Curl in ream Cut edge conditions Fusing compatibility Grain Moisture content Specifications 5.5 pH or lower 0.094 ~ 0.18 mm (3.0 ~ 7.0 mils) Flat within 5 mm (0.02 in.) Cut with sharp blades with no visible fray. Must not scorch, melt, offset, or release hazardous emissions when heated to 200 °C (392 °F) for 0.1 second. Long grain 4 % ~ 6 % by weight Paper Output Capacity Output Location Face-down output tray Face-up output slot Capacity 150 sheets of 75 g/m2 bond (20 lb) paper 1 sheet of 75 g/m2 bond (20 lb) paper Paper Storage Environment Paper storage environmental conditions directly affect the feed operation. E.8 Specifications