Yamaha ELB-02 ELB-02_Owners Manual - Page 204
Fit the Grill Net onto the Speaker., the bottom surface of the main Unit.
![]() |
View all Yamaha ELB-02 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 204 highlights
6-2 Use the four screws (A) to fasten the Main unit to the Sideboards as shown in the illustration. 8 Plug the power cord into the AC IN jack on the bottom surface of the main Unit. A A 7 Fit the Grill Net onto the Speaker. First, align the net with the bottom line, then secure it to the speaker assembly. 9 Connect the Pedalboard cord and Speaker cord to the Main Unit. Remove the protective film applied to each connector of the cords. Make sure that the latches on each connector of the cords face toward you, and connect them to each socket securely until the latch is set. Once connected securely, the connector cannot be accidentally disconnected, even if you pull the connector gently downward. (If disconnected, the pedals will not function properly.) Speaker cord Pedalboard cord To disconnect the Pedalboard cord and Speaker cord: Press the bottom of the latch to unlatch, then disconnect. 10 Affix the two cord holders to the inside of the side board, then insert the Pedalboard cord in the holders as shown in the illustration. Clamp the holder shut after inserting the cord. 11 Fasten the Grill Net by inserting the knobs into the holes. Appendix 204 ELB-02 Owner's Manual
![](/manual_guide/products/yamaha-elb02-elb02owners-manual-e49e460/204.png)