Yamaha ELB-02 ELB-02_Owners Manual - Page 34

3 Select the Voice in the Voice menu display by rotating the DATA CONTROL dial. You can also select by pressing the [A]/[D] buttons. Voices 2 Now go on to select voices for the Lower keyboard and Pedalboard as you did for the Upper keyboard above. Adjusting the Voice volume There are two ways to set the Voice volume: using the Volume buttons on the panel and setting the volume in the display. The Volume buttons let you make coarse adjustments to the volume while the setting in the display gives you fine control. Using the VOLUME buttons on the panel (coarse) Press one of the Volume buttons of each Voice section on the panel to set the desired level for each Voice. The controls have five volume settings, from a minimum of 0, or no sound, to a maximum of full volume. Increasing the volume Decreasing the volume NOTE Depending on the volume value (set in the Voice Condition display), two adjacent Volume button lamps may be lit at the same time, indicating an intermediate position. NOTE Although setting the on/off status of the Voice section to off in the Voice Display results in a Volume value of 0 in the Voice Condition display, it will change to on when you increase the Volume value in the Voice Condition display or by using the panel Volume buttons, even if you have set it to off. Setting the Volume in the display (fine) Pressing the same Voice button on the panel again after selecting the Voice calls up the Voice Condition display. The Volume is displayed in the top of the Voice Condition display Page 1. Press the [A] button to select the "VOLUME" item, then adjust the volume by using the DATA CONTROL dial. The range of the Fine volume control is 0 - 24. Voice Condition Display [Page 1] 34 ELB-02 Owner's Manual