Yamaha TYROS Owners Manual - Page 46

Singing with a Connected Microphone, Connecting a microphone, Singing Along with Lyrics

Page 46 highlights

Quick Guide Singing with a Connected Microphone Reference on page 130 The TYROS is equipped with an input jack, letting you connect another audio source - such as a microphone for your voice, an electric guitar, or a CD player - and mix it with the sounds of the TYROS. The fun doesn't stop there, however. With the Vocal Harmony feature (page 47), you can also apply various harmony and echo effects to your voice or guitar playing. Or use the TYROS for karaoke and singalongs - applying various DSP effects to your voice, as you sing with the auto accompaniment or song playback. Connecting a microphone 1 Set the [TRIM] control on the rear panel and the [INPUT VOLUME] on the front panel both to "MIN." MIC / LINE IN INPUT TRIM MIN MAX INPUT VOLUME MIC /LINE IN SIGNAL OVER FADE IN / OUT MIN MAX 2 Connect a microphone to the MIC/LINE IN jack. The MIC/LINE jack accepts 1/4" phone plugs. MIC / LINE IN INPUT TRIM MIN MAX • To avoid possible feedback or other interference, separate the microphone from the speakers as much as possible. • Since the MIC/LINE IN jack is highly sensitive, it may pick up and produce noise when nothing is connected. To avoid this, always set the INPUT VOLUME to minimum when nothing is connected to the MIC/LINE IN jack. 3 Turn the power on. 4 Adjust the [TRIM] control on the rear panel and the [INPUT VOL- UME] on the front panel while singing into the microphone. • Since the input level from the microphone may be low, set the [TRIM] control close to "MAX." • Adjust the controls while checking the OVER and SIGNAL lamps. MIC / LINE IN INPUT TRIM MIN MAX INPUT VOLUME MIC / LINE IN SIGNAL OVER FADE IN / OUT MIN MAX The OVER lamp lights when the input level is too high. Make sure to adjust the INPUT VOLUME so that this lamp does not light. The SIGNAL lamp lights to indicate that an audio signal is being received. • Make sure to set the [INPUT VOLUME] to "MIN" before performing the following operations. • Connecting a microphone to the TYROS • Removing a microphone from the TYROS • Turning the TYROS' power off • You may find that microphone sound is distorted, even though the OVER lamp is not lit. If so, try setting the [TRIM] control on the rear panel close to "MIN" and adjusting the [INPUT VOLUME] control on the front panel until the level is appropriate. • Since the input level from the mixer or audio equipment may be high, set the [TRIM] control on the rear panel close to "MIN." Singing Along with Lyrics Try playing a song that contains lyric data, then sing along with it using the connected microphone. 1 Select a song that contains lyric data (page 43). 2 Go back to the Main display by pressing the [EXIT] button and press the [Lyrics] LCD button to call up the Lyrics display. A B C D E 46 TYROS Owner's Manual 44

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176

46
Quick Guide
TYROS Owner’s Manual
Reference on page 130
Singing with a Connected Microphone
Connecting a microphone
1
Set the [TRIM] control on the rear panel and the [INPUT VOLUME]
on the front panel both to
MIN.
2
Connect a microphone to the MIC/LINE IN jack.
The MIC/LINE jack accepts 1/4” phone plugs.
3
Turn the power on.
4
Adjust the [TRIM] control on the rear panel and the [INPUT VOL-
UME] on the front panel while singing into the microphone.
• Since the input level from the microphone may be low, set the [TRIM] control close
to “MAX.”
• Adjust the controls while checking the OVER and SIGNAL lamps.
Singing Along with Lyrics
Try playing a song that contains lyric data, then sing along with it using the connected microphone.
1
Select a song that contains lyric data (page 43).
2
Go back to the Main display by pressing the [EXIT] button and
press the [Lyrics] LCD button to call up the Lyrics display.
The TYROS is equipped with an input jack, letting you con-
nect another audio source
such as a microphone for your
voice, an electric guitar, or a CD player
and mix it with the
sounds of the TYROS.
The fun doesn
t stop there, however.
With the Vocal Harmony feature (page 47), you can also
apply various harmony and echo effects to your voice or
guitar playing.
Or use the TYROS for karaoke and sing-
alongs
applying various DSP effects to your voice, as
you sing with the auto accompaniment or song playback.
FADE
IN/OUT
MAX
INPUT VOLUME
MIN
OVER
SIGNAL
MIC/LINE IN
INPUT
MIC / LINE IN
TRIM
MIN
MAX
To avoid possible feedback or
other interference, separate the
microphone from the speakers as
much as possible.
Since the MIC/LINE IN jack is
highly sensitive, it may pick up
and produce noise when noth-
ing is connected. To avoid this,
always set the INPUT VOLUME
to minimum when nothing is
connected to the MIC/LINE IN
jack.
INPUT
MIC / LINE IN
TRIM
MIN
MAX
FADE
IN/OUT
MAX
INPUT VOLUME
MIN
OVER
SIGNAL
MIC/LINE IN
INPUT
MIC / LINE IN
TRIM
MIN
MAX
The OVER lamp lights when the input
level is too high.
Make sure to adjust the
INPUT VOLUME so that this lamp does
not light.
The SIGNAL lamp lights to indicate that
an audio signal is being received.
Make sure to set the [INPUT VOL-
UME] to “MIN” before performing
the following operations.
Connecting a microphone to the
TYROS
Removing a microphone from
the TYROS
Turning the TYROS’ power off
You may find that microphone
sound is distorted, even though
the OVER lamp is not lit.
If so, try
setting the [TRIM] control on the
rear panel close to “MIN” and
adjusting the [INPUT VOLUME]
control on the front panel until the
level is appropriate.
Since the input level from the
mixer or audio equipment may be
high, set the [TRIM] control on the
rear panel close to “MIN.”
A
B
C
D
E
44