2010 Ford Expedition EL Owner Guide 1st Printing (Spanish) - Page 626

Driver Controls Note: The Car2U௡ system allows for three devices to be programmed. If you need to change or replace any of the three devices after it has been initially programmed, it is necessary to erase the current settings using the Erasing the Car2U௡ Home Automation System buttons procedure and then programming all of the devices being used. Fixed code programming Note: Do not program the Car2U௡ system with the vehicle in the garage. Make sure that your key is on and engine off while programming the transmitter. 1. To program units with fixed code DIP switches, you will need the garage door hand-held transmitter, paper and a pen or pencil. 2. Open the battery cover and record the switch settings from left to right for all 8 to 12 switches. Use the figure below: When a switch is in the up, on, or + position, circle "L." When a switch is in the middle, neutral, or 0 position, circle "M." When a switch is in the down, off, or - position, circle "R." Switch position 1 2 3 4 Up, on L L L L or + Middle, neutral M M M M or 0 Down, R R R R off or - L=left; M=middle; R=right 152 5 L M R 6 L M R 7 L M R 8 L M R 9 L M R 10 L M R 11 L M R 12 L M R 2010 Expedition (exd) Owners Guide (own2002), 1st Printing USA (fus)